Vissa benämningar från TecDoc kan visas på det språk som finns i källan.
Impulsgivare, vevaxel Original VEMO Quality
V46-72-0116
Viktiga egenskaper:
- Tillverkare: VEMO
- SKU: V46-72-0116
- Specifikationer: Polantal: 2; för OE-nummer: 82 00 885 209; Motstånd [Ohm]: 700; Sensortyp: induktiv; Antal anslutningar: 2; Nominell spänning [V]: 12; Installationsdjup [mm]: 47; Kompletteringsartikel/tilläggsinfo 2: för vevaxeln; Kompletteringsartikel/tilläggsinfo 2: utan abel; Kontakthållarform: oval; Vikt [kg]: 0.036; Förpackningsbredd [cm]: 4; Förpackningsbredd [cm]: 5.647; Förpackningshöjd [cm]: 6.7; Förpackningshöjd [cm]: 2.487; Förpackningsdjup [cm]: 6.8; Förpackningsdjup [cm]: 6.958
- Status: Normal
- Antal per enhet: 1
- Mediastandard: Bild
- Fri fraktFör beställningar mellan 20 $ och 50 $
- Support dygnet runtRing oss när du vill
- 100 % säkertEndast säkra betalningar
- Utvalda erbjudandenUpp till 90 % rabatt
Kortinformation
-Installation safety through vehicle-specific coded
connectors.
-high precision fit of the sensor head for guaranteed correct
position detection of the flywheel
-Use of permanent magnets in the sensor head to obtain the
static magnetic field ("long life")
-Products supplied by us are without exception intended for
the designated use.
Please note that our products are usually delivered without
installation instructions.
Installation may only be carried out by trained specialist
personnel.
There is no guarantee for inappropriate, improper or
unintended use.
-In the warranty, we always make a distinction between wear
parts and vehicle parts. All wear parts are subject to a
reduced warranty period and a maximum mileage. For the
following wear parts, the warranty periods are limited as
follows:
EGR valve 15,000 km
Throttle bodies 15,000 km
Air flow meter 15,000 km
Brake components such as brake disks, brake pads, etc.
maximum of 1000 km (break-in period). Therefore, warranty
claims for brake parts are only reviewed with an
installation invoice and a record of the wheel hub run-out
measurement, including photos.
For brake disks and brake pads, the break-in requirements
specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be
checked with regard to clearance and the wheel hub with
regard to wobble, and the appropriate documentation must be
produced.
If the vehicle is no longer in its original condition due to
tuning work such as wheel accessories and tracking plates,
the entitlement to make warranty claims is lost due to
third-party work. The same warranty claims are lost if the
vehicle is used for motor sports or similar events.
Uppgifter om tekniska egenskaper, leveransens innehåll, tillverkningsland och utseende är vägledande och bygger på den information som fanns vid publiceringen.

